Vapor‐Phase Reaction of Citronellal over Mesoporous Molecular Sieves MCM‐41 and Zeolites

The vapor‐phase reaction of citronellal (CTN) at 220 °C and atmospheric pressure has been studied using mesoporous molecular sieves and zeolites in a fixed‐bed reactor. The primary products included isopulegol (IPG), menthone, and pulegol with subsequent reactions to form cyclic hydrocarbons. The CTN conversion and the product selectivity depend on the acidity and the textural property of catalysts. Lewis and/or Brönsted acid sites are essential for catalyzing this reaction. An increase of SiO₂/Al₂O₃ mol ratio diminishes the acid amount of all catalysts and enhances both the surface area and the structural order of MCM‐41. The catalytic activity follows the order of MCM‐41 > HZSM‐5 > Hβ > USY, in accordance with the relative total acid amount except that of MCM‐41. Despite its low acidity, Si‐MCM‐41 exhibits the best catalytic performance due to its uniform mesopores, large surface area and good stability; the CTN conversion and the IPG yield attain 91.9% and 58.6%, respectively, after at least 25 h time‐on‐stream.     

Further studies on synthesis of the 12,13-seco norditerpenoid alkaloids

After a series of optimization for the reaction conditions (reagents, reaction temperature, etc.), treatment of the sulfonates 4, 8, 13 and 15 with 8% NaOH (room temperature, 24 h) via a semipinacol rearrangement afforded the corresponding C-nor compounds 5, 9, 12 and 16, as the major of a pair of epimer at C-16, to an excellent extent, in 95%, 92%, 100% and 90% yield, respectively. The 12,13-seco compounds 21 and 22 (23) were obtained in 20% and 60% yield, respectively, by treating 5 with Br(2)-glacial HOAc (room temperature, 24 h). Treatment of the C-nor compounds 5 or 6, 16 or 17, and 28 from 10 with SOCl(2)-anhydrous benzene (room temperature, overnight) afforded the 12,13-seco compounds 24, 26 and 30 in 70% or 100%, 40% and 66% yield, respectively. When treatment of the C-nor compound 29 from 9 under same conditions gave the 12,13-seco products 30, 31 and 32 in 33%, 26% and 20% yield. When treating 21 or 24, and 26 with 5% KOH in EtOH afforded the 12,13-seco compounds 25 and 27 quantitatively, respectively. The compound 31 converted to 30 quantitatively by treatment with Na(2)CO(3) in MeOH. All of the new compounds were isolated and fully characterized.     

Electron paramagnetic resonance study of amphiphiles partitioning behavior in desiccation-tolerant moss during dehydration

Desiccation tolerance is a crucial characteristic for desert moss surviving in arid regions. Desiccation procedure always induces amphiphiles transferring from the polar cytoplasm into lipid bodies. The behavior of amphiphiles transferring can contribute to the enhancement of desiccation tolerance and the reduction of plasma membrane integrity simultaneously. The effects of amphiphiles partitioning into the lipid phase during water loss has been studied for pollen and seeds using electron paramagnetic resonance (EPR) spectroscopy. However, desiccation-tolerant high plants occur among mosses, several angiosperms and higher plants seeds or pollens. They have different strategies for survival in dehydration and rehydration. A desiccation-tolerant moss Tortula desertorum was used to investigate the behaviors of amphiphilic molecules during drying by spin label technology. There are small amount of amphiphilic probes partitioning into membrane during moss leaves dehydration, comparing with that in higher plants. Cytoplasm viscosity changed from 1.14 into glass state only dehydration less than 60 min. Moss leaves lost plasma membrane integrity slightly, from 0.115 to 0.237, occurred simultaneously with amphiphiles partition. The results showed the more advantages of mosses than higher plants in adapting fast dehydration. We propose that EPR spin label is feasible for studying the amphiphiles partitioning mechanisms in membrane protection and damage for desiccation-tolerant mosses.     

Effects of annealing treatment on the properties of MEH-PPV/titania hybrids prepared via in situ sol-gel reaction

A uniform poly[2-methoxy-5-(2′-ethylhexyloxy)-p-phenylenevinylene] (MEH-PPV)/titania hybrid film was successfully prepared by an in situ sol-gel reaction of titanium isopropoxide (TIP) in the presence of MEH-PPV/2-chlorophenol solution. The annealing treatment increased the conversion of TIP to titania as determined from evidence of the formation of Ti-O-Ti bonds in the Fourier transform infrared (FTIR) spectrum. Scanning electronic microscope (SEM) photographs showed that the morphology and distribution of titania in the hybrid film were strongly related to the amount of water in the in situ sol-gel reaction. The thermal stability of MEH-PPV/titania hybrids was enhanced by the annealing treatment. Small angle X-ray scattering (SAXS) and X-ray diffraction (XRD) analyses indicated that annealing treatment promoted the ordered aggregation of the MEH-PPV chains and crystallization of titania to a certain extent. The blue shift in Ultraviolet-visible (UV-vis) absorption of pure MEH-PPV after annealing was ascribed to the small extent of decomposition and coil conformation which occurred at high temperature. A more-obvious blue shift for the hybrids was observed, which resulted from irregular aggregation and coil conformation of the MEH-PPV chains induced by heterogeneous point, TIP (titania). The red shift in the photoluminescent (PL) emission for pure MEH-PPV resulted from a certain extent of ordered aggregation after annealing. However, only a slight red shift in the PL emission peak for the hybrids was found due to the hindrance of ordered aggregation of MEH-PPV chains in the presence of TIP (titania).     

Comparative study on the synthesis, photoluminescence and application in InGaN-based light-emitting diodes of TAG:Ce phosphors

Cerium-doped terbium aluminum garnet phosphors, Tb₃Al₅O₁₂:Ce³⁺ (TAG:Ce³⁺), were prepared with different methods: co-precipitation (CP), half dry-half wet (HDHW), sol-combustion (SC) and Pechini method plus conventional solid state reaction (SS) method. Comparative study on the phase-formation, particle size, morphologies and luminescent characteristics of the phosphors synthesized with different methods was carried out by means of XRD, FE-SEM and photoluminescence (PL) analysis and SC method was confirmed by the comparison of the results to be an easy and an effective process for preparing efficient and nano-sized Tb₃Al₅O₁₂:Ce³⁺ phosphors. Various factors influencing particle size, morphology and PL of the phosphors, such as precursor preparation, reaction temperature and heating time, were also investigated. Light-emitting diodes (LEDs) were fabricated with each phosphor and a ∼460 nm emitting InGaN chip. The LEDs from SS, HDHW and CP exhibit strong white emission while those from SC and Pechini emit yellow, revealing that the emission characteristics of LEDs are influenced not only by the morphology and the particle size of the phosphors, but also by the preparing process of the phosphors.     

Hydrothermal Synthesis and X‐Ray Structural Characterization of Manganese,Nickel, and Cadmium Coordination Polymers Containing 2,3‐Pyridinedicarboxylate as Multidentate Ligands

Three divalent transiton‐metal complexes of 2,3‐pyridinedicarboxylate (2,3‐pda²), [Mn(2,3‐pda)‐(H₂O)3]_∞ ( 7 ), [Ni(2,3‐pda)(H₂O)3]_∞ ( 8 ), and [Cd2(2,3‐pda)₂(H₂O)]_∞ ( 9 ) have been hydrothermally synthesized and structurally characterized. X‐ray diffraction analyses reveal that compounds 7 and 8 are zigzag‐ and linear‐type one‐dimension (1D) coordination polymers, respectively, whereas compound 9 is a three‐dimension (3D) coordination polymer. A simple comparison of the coordination geometries with the available neutral analogues {M_x(2,3‐pda)_x(H₂O)_y}_∞ containing one or two divalent transition‐metal atoms and equal ligands in the presence or absence of coordinated water molecules is also presented.     

Synthesis and structure of Mn(II) and Zn(II) complexes containing 1,10-phenanthroline unit

The Mn(II) and Zn(II) complexes of N,N′-diisopropyl-1,10-phenanthroline-2,9-dimethanamine have been synthesised, and the structure of the two complexes have been studied by X-ray crystallography.     

聚硅氧烷涂敷的反相高效液相色谱固定相

用甲基乙烯基聚硅氧烷涂敷于硅烷化的微粒硅胶上，制备出一种新型的涂敷型反相高效液相色谱固定相。该固定相对极性、非极性和碱性化合物均有良好的分离能力，峰对称性好。对其恶性循环 了考察，连续使用三个月后，固定相的碳量和色谱性能仍保持不变。     

2,6—二氯—4—溴偶氮胂光度法测定微量铀（Ⅵ）

本报道用了２，６－二氯－４－溴偶氮胂作显色剂测定微量铀（Ⅵ）的光度法。在Ｈ２ＳＯ４介质中，铀（Ⅵ与）２，６－二氯－４－溴偶氮胂形成１：２络合物，其λｍａｘ＝６４０ｎｍ；表观摩尔吸光系数为１．１×１０＾５Ｌ．ｍｏｌ＾－＾１．ｃｍ＾－＾１；铀的浓度在０．０－２２．０μｇ／ｍｌ内符合比耳定律。方法具有灵敏度高，选择性好，操作方便等特点并已用于废水及矿样中微量铀（Ⅵ）的测定。